Author: Try it Rob via YouTube
Go to Source
Ender 3 Pro to Voron Switchwire – Part 3 Assembling the Klicky Probe
In this video, we’ll focus on assembling the Klicky probe step by step. This part is all about putting the probe together — preparing the printed parts, magnets, and hardware — so it’s ready for installation in the next stage of the conversion.
🔧 What you’ll see in this video:
– Overview of the Klicky probe parts and hardware
– Step‑by‑step assembly process
– Tips for alignment and magnet placement
– Preparing the probe for future installation on the Voron Switchwire
If you haven’t seen Part 1 (EBB CAN board) or Part 2 (U2C board), check those out first to follow the full Ender 3 Pro to Voron Switchwire journey.
👉 Stay tuned for the next video, where we’ll install and configure the Klicky probe for automatic bed leveling.
#Voron #Switchwire #3DPrinting #Klipper #KlickyProbe
